Honda BF40D Manuel D'utilisation page 328

9) Install the lower rubber mount on the extension case
aligning the cutout in the lower mount center housing with
the cutout in the lower rubber mount as shown.
1
10) Install the 12 mm washer [small] and the 12 x 162 mm hex
2
bolt. Holding the 12 x 162 mm hex bolt with a wrench,
tighten the 12 mm washer [large] and the 12 mm self-
locking nut to the specified torque.
3
TORQUE: 55 N . m (5.6 kgf . m, 41 lbf . ft)
4
5
6
7
8
9
10
11
12
11) Install the 116 mm lead wire on the extension case, and
13
tighten the 6 x 8 mm screw securely.
14
12) Install the lower mount housing on the extension case, and
tighten the two 8 x 25 mm flange bolts to the specified
15
torque.
TORQUE: 22 N . m (2.2 kgf . m, 16 lbf . ft)
16
13) Remove the engine hanger chain from the engine hangers,
17
and lower the outboard motor to the lowermost position.
18
19
20
11-54
[1]
12 x 162 mm
HEX BOLT
[2]
12 mm WASHER
[SMALL]
[3]
LOWER RUBBER
MOUNT
[4]
12 mm WASHER
[LARGE]
[5]
12 mm SELF-LOCKING NUT
[6]
LOWER MOUNT
CENTER HOUSING
[7]
CUTOUT
[2]
6 x 8 mm SCREW
[1]
LOWER MOUNT
HOUSING
[4]
8 x 25 (2)
8 mm WASHER (4)
328
[3]
LOWER RUBBER
MOUNT
[3]
116 mm
LEAD WIRE