Alternator Cover - Honda BF40D Manuel D'utilisation

1. ALTERNATOR COVER

1 a. REMOVAL/INSTALLATION
1) Remove the engine cover (P. 4-2).
2) Remove the 13 mm wire harness clip from the alternator cover.
2
3) Release the main wire harness from the clamp on the alternator cover.
4) Release the IAT sensor wire from the clamp on the alternator cover.
3
5) Remove the three 6 x 25 mm bolt-washers and the 6 x 25 mm flange bolt, and remove the alternator cover.
4
• Installation is the reverse order of removal.
5
6
[1]
6 x 25 mm BOLT-WASHER (3)
7
8
9
10
11
12
13
14
15
16
17
[5]
IAT SENSOR WIRE
18
19
20
7-2
6 x 25
20
[2]
ALTERNATOR COVER
[3]
MAIN WIRE
HARNESS
[4]
13 mm WIRE
HARNESS CLIP