Honda BF40D Manuel D'utilisation page 464

10) Apply ATF to a new O-ring and install it on the valve comp. B.
11) Apply ATF to the outer surface of the valve comp. B, and
1
install it in the spool valve.
Note the installation direction of the valve comp. B.
2
12) Apply ATF to a new O-ring and install it on the spool valve
cap.
3
13) Tighten the spool valve cap to the specified torque using a
4
commercially available driver socket [width: 2.8 mm
(0.11 in)].
5
TORQUE: 22 N . m (2.2 kgf . m, 16 lbf . ft)
6
7
8
9
10
11
12
14) Apply ATF to the seal washer and install it in the cylinder
13
comp.
14
NOTICE
Install the seal washer with care not to move it out of
15
position or collapse it in the cylinder comp.
16 15) Apply ATF to a new O-ring and D-ring, and install them on
the manual valve.
17
16) Tighten the manual valve to the specified torque, and
install the internal circlip in the groove inside the cylinder
18
comp. securely.
TORQUE: 1.7 N . m (0.2 kgf . m, 1.3 lbf . ft)
19
20
14-23
[2]
VALVE COMP. B
(UPPER CHAMBER
SIDE)
[1] O-RING
(ATF)
[3]
SPOOL VALVE
CAP
[5]
DRIVER SOCKET
[WIDTH: 2.8 mm (0.11 in)]
(Commercially available)
[1] MANUAL VALVE
[3] D-RING
(ATF)
[1]
MANUAL
VALVE
464
[3] SPOOL VALVE
CAP
[4] VALVE COMP. B
[1] O-RING
[1] O-RING
[3]
SPOOL
VALVE
CAP
[2] O-RING
[4] SEAL WASHER
[3] D-RING
[2] O-RING
[5] INTERNAL
CIRCLIP