Honda BF40D Manuel D'utilisation page 374

13) Remove the swivel case assembly, and remove the 22 mm
wave washer.
14) Remove the two swivel case bushings from the swivel case
assembly.
Check the swivel case bushings for wear, damage or
deformation, and replace them with new ones if necessary.
15) Remove the tilting shaft from the R. stern bracket.
16) Remove the tilting bolt cap and the 7/8-14 UNF self-locking
nut from the tilting shaft.
Replace the 7/8-14 UNF self-locking nut with a new one on
reassembly.
b. INSPECTION
[POWER TRIM/TILT TYPE ONLY]
• TRIM ANGLE SENSOR
Measure the resistance between the following terminals.
Between Light green/Black and Black terminals
Between Yellow/Blue and Black terminals
If the measurements are outside the specification, replace the
trim angle sensor.
13-14
[1]
SWIVEL CASE
BUSHING (2)
[7]
22 mm WAVE
WASHER
[6]
R. STERN
BRACKET
[5]
TILTING SHAFT
[4]
7/8-14 UNF SELF-
LOCKING NUT
[1]
TRIM ANGLE SENSOR
4 - 6 k
2.9 - 4.4 k
374
[2]
SWIVEL CASE
ASSEMBLY
[3]
TILTING BOLT CAP
Lg/Bl
Bl
Y/Bu