Inspection - Honda BF40D Manuel D'utilisation

3. INSPECTION

1 • COMBINATION SWITCH
Check for continuity between the terminals with the switch in
each position.
2
Wire
3
Position (Bl)
OFF (Stop)
4
ON (Run)
START (Start)
5
: Continuity
6
Replace the switch with a new one if it is not normal.
7
• EMERGENCY STOP SWITCH
Attach the tester leads to the terminals and check for
8 continuity.
Switch clip position
9
Set
Not set
10
Switch is pushed with switch
clip being set
11
If there is any abnormality, replace the switch with a new one.
12
• WARNING BUZZER
13
• Use a known-good battery.
14
Connect the black/yellow terminal of the warning buzzer to the
battery positive (+) terminal, and the yellow/green terminal to
15
the battery negative (-) terminal as shown. Check that the
buzzer sounds this time.
16
If it does not, replace the buzzer with a new one.
17
18
19
• POWER TRIM/TILT SWITCH [POWER TRIM/TILT
20
TYPE ONLY]
Check for continuity between the terminals with the switch in
each position.
UP (Up)
Neutral
DN (Down)
: Continuity
If there is any abnormality, replace the switch with a new one.
15-8
E IG BAT LO
(Bl/R) (W/Bl) (Bl/Y)
Continuity
No
Yes
Yes
Light blue White/black Light green
ST
(Bl/W)
12 V
[1] UP (Up)
[2]
DN (Down)
556
Bl/W
Bl/R
Bl/Y
Bl
W/Bl
[1]
SWITCH CLIP
[4]
[3]
LIGHT GREEN
WHITE/
BLACK
[5]
LIGHT
BLUE