Propeller Shaft Holder Assembly - Honda BF40D Manuel D'utilisation

3. PROPELLER SHAFT HOLDER
ASSEMBLY
1
a. REMOVAL/INSTALLATION
2
1) Remove the propeller (P. 11-2).
3
2) Remove the two 8 x 30 mm bolt washers.
4 3) Insert a screwdriver or equivalent tool into the recesses in
the propeller shaft holder and remove the propeller shaft
holder assembly from the gear case.
5
6
Installation is the reverse order of removal. Note the following.
7
• Check the propeller shaft thrust clearance after installation (P.
11-8).
• Perform gear case pressure check after installation (P. 11-45).
8
9
10
11
12
13
14
15
16
17
18
19
20
[5]
GEAR CASE ASSEMBLY
11-7
[4]
(Apply marine grease to the O-ring and
to the insertion part in the gear case.)
[1]
RECESSES
[3]
PROPELLER SHAFT
HOLDER ASSEMBLY
234
[2]
PROPELLER
SHAFT HOLDER
ASSEMBLY
[1]
69 x 3.1 mm O-RING
Do not reuse.
[2]
8 x 30 mm BOLT
WASHER (2)