Unfolding The Chair - Stryker 6254 Mode D'emploi

English

UNFOLDING THE CHAIR

To unfold the chair:
1 . Stand behind the chair .
2 . Apply the wheel locks (if desired) .
3 . Pull the backrest and the extension handle apart . The lock mechanism will automatically engage when the chair
is completely unfolded .
4 . Verify the lock is engaged by pulling up on the seat . If the lock is properly engaged, the chair will not fold .
WARNING
An unlocked chair can fold during use, causing injury to the passenger or operator . Always make sure the chair is locked
in the unfolded position before use .
FOLDING THE CHAIR
To fold the chair:
1 . Apply the wheel locks (if desired) . Buckle the restraint straps and fold them neatly to prevent them from interfering
with proper folding of the chair . Secure the head support strap behind the chair frame .
2 . Stand at the side of the chair .
3 . Pull up on the red lock bar at the rear of the chair .
4 . Tip the chair forward .
5 . Fold the seat up to the backrest until the front legs lock in the clips on the bottom of the seat tube .
Note: Rotate the front casters so they do not interfere with folding the chair .
Store the Evacuation Chair in a cool, dry environment that is above freezing temperature and out of direct sunlight .
Return To Table of Contents
1-12
Operation Guide
RED FOLD
LOCK BAR
Figure 1- Unfolding/Folding the Chair
6254-009-005 REV B www.stryker.com