Replacing A Multipole Module With A Bus Coupler - Aventics CANopen VS CL03 Série Mode D'emploi

92 AVENTICS | CANopen | R402003660–BAL–001–AE
Replacement
1
Fig. 6: Replacing a multipole module with a bus coupler, example
6. Copy all the settings from the old bus coupler to the new bus
coupler (see "Making settings" on page 81).
7. Re-establish the electrical and pneumatic connections.
8. Check the section "Configuring the bus system" on page 86
and adjust the configuration if necessary.
8.2
Applied electric voltage and high pressure
Danger of injury from electric shock and sudden pressure drops.
Make sure the system is not under pressure or
connected to power when you exchange a module.
2
1. Unscrew the three screws (1) that fit the multipole connector
module (2) to the valves (hexagonal head, wrench size 8 mm).
2. Detach the module from the valve subbases (3).
Replacing a multipole module with a bus
coupler
WARNING
3
4
5