Commissioning And Operation; Selecting The Valve Supply - Aventics CANopen VS CL03 Série Mode D'emploi

84 AVENTICS | CANopen | R402003660–BAL–001–AE

Commissioning and operation

S4
Pos. 2 ↑
Pos. 1 ↓
Table 11: S4 switch assignment
Switch
S4.1 Power supply control byte 1
S4.2 Power supply control byte 2
S4.3 Power supply control byte 3
S4.4 Power supply control byte 4
1)
Examples Subbases used
Example 1 Subbases for double solenoid valves
Example 2 Subbases for double solenoid valves
Example 3 Subbases for double solenoid valves
1)
You can also arrange other combinations based on your requirements.
7.1.5
The valve power supply can be selected block-wise with the S4
sliding switch. It is possible to switch between valve supply from
the CANopen line and the U
external supply.
At delivery, all switches are set to position 1.
Voltage on switches
Switches can be damaged if voltage is applied to them during
operation.
Always operate switches in a voltage-free state!
How to assign the valve supply:
Using the S4 switch, assign one of the two supply voltages
U or U
Q1
Function
The following example combinations are available for the
assignment of the S4 switch and the supply of assembled
valves for 32 valve solenoids in Table 12.

Selecting the valve supply

Q1
to each valve group (see Table 11 below).
Q2
Position 1 (down)
U (external supply,
Q1
pin 2, white)
U (external supply,
Q1
pin 2, white)
U (external supply,
Q1
pin 2, white)
U (external supply,
Q1
pin 2, white)
Valve equipment
Double solenoid valves
Single solenoid valves
Single and double solenoid valves
and U voltages from the
Q2
Position 2 (up)
U (external supply,
Q2
pin 4, black)
U (external supply,
Q2
pin 4, black)
U (external supply,
Q2
pin 4, black)
U (external supply,
Q2
pin 4, black)