Scale/Bed Exit Board/Beeper Replacement (Optional) - Stryker GoBed II MedSurg Bed Guide D'entretien

SCALE/BED EXIT BOARD/BEEPER REPLACEMENT (OPTIONAL)

Tools Required:
• #2 Phillips Screwdriver
• 3/8" Combination Wrench
• Needle Nose Pliers
B
Procedure:
1 . Raise the bed to the highest position and apply the brakes .
2 . If applicable, remove the plastic litter cover (if equipped) and raise the fowler to the highest position .
3 . Unplug the power cord from the wall receptacle .
4 . Using a #2 Phillips screwdriver, remove the two screws (A) holding the cover plate .
5 . Properly ground yourself (see "Grounding Diagram" section) .
To replace the Bed Exit Beeper, proceed with steps 6 to 9.
To replace the scale/bed exit board, proceed with steps 10 to 14
6 . Disconnect the beeper cable from J3 of the control board .
7 . Lift the beeper (B) to remove it from the plate . Remove any glue residue .
8 . Reverse the above steps to install the new beeper .
9 . Test the Bed Exit system to make sure the beeper operates properly .
10 . Remove all cables connected to the control board . Note the cable locations in order to reconnect them correctly .
Refer to drawing OL280005L,
11 . Using a 3/8" combination wrench, remove the nut holding the ground cable to the scale board (B) .
12 . Using needle nose pliers, pinch the upper part of the stand-off pins and lift the defective board up and out .
13 . Reverse the above steps to install the new scale control board .
Note
Be sure to reconnect the load cell cables on the scale/bed exit board in the proper order . Refer to Figure 13 when
reconnecting the load cell cables .
14 . Calibrate the scale before returning the bed to service . Refer to the "Scale Calibration" procedure,
www.stryker.com
Service Information
A
C
page 1-76) for the connecting position of the cables on the scale/bed exit board .
280C-009-002 REV B
Head Right
Foot Left
Cell Cable
Cell Cable
A C
B
Head Left
Foot Right
Cell Cable Cell Cable
Figure 13
Return To Table of Contents
D
page 1-55 .
1-51