Operating The Optional Scale System - Stryker M Série Mode D'emploi

OPERATING THE OPTIONAL SCALE SYSTEM

4.
2.
1. Display - Displays patient weight, unit of measurement and battery status .
2. "Zero" - Push and hold for 2 seconds to zero the scale system before putting a patient on the stretcher . If the
display flashes "hold", press and hold the "Zero" button again until the display reads "rEL" (release) . Release the
"Zero" button . The display flashes "000 .0", then displays "000 .0" . The system is not zeroed until the "000 .0" stops
flashing . For the most accurate results, always zero the scale system before putting a new patient on the stretcher .
The display will shut off after approximately 40 seconds .
3. "Weigh" - Push to weigh the patient . The display will show the patient's weight for approximately 40 seconds before
turning off .
4. "lb/kg" - Push to display patient weight in pounds or kilograms .
Note
Do not touch the stretcher while the scale system is weighing or zeroing .
The patient must remain still while the system is weighing . If the patient is moving, the system will try for 20 seconds to
get a stable weight or zero value before displaying the error message
If there is a loose connection or a malfunctioning component, the display will show "Err" . Attempt the function again . If
the system is functional, "Good" will display and the scale system is ready to use . If the malfunction is still present, the
display shows "Err" again . Call Stryker technical support at 800-327-0770 .
For the most accurate results, weigh the patient with the litter at zero degrees of Trend .
SYMBOL
Weigh
Zero
lb/kg
Return To Table of Contents
1-22
Stretcher Operation
1.
ACTION
Press and release "WEIGH" .
Press and hold "ZERO"
Release "ZERO"
To convert the patient's weight to
kilograms, press and release "lb/kg"
Repeat to return to pounds .
1025-009-005 REV B
3.
Battery Charge Level Indicator
.
.
DISPLAY
- - - -
"XXX .X lb"
"hold"
"rEL"
"000 .0" (flashing)
"000 .0 (solid)"
"XXX .X kg"
"XXX .X lbs"
www.stryker.com