Publicité
È
È
È
FRONT BRAKE AND REAR BRAKE
É
É
É
3. Install:
• Caliper 1
• Rear wheel 2
Refer to "FRONT WHEEL AND REAR
WHEEL" section.
4. Tighten:
• Pad pin 3
5. Install:
• Pad pin plug 4
Master cylinder kit
1. Clean:
• Master cylinder
• Master cylinder kit
Clean them with brake fluid.
2. Install:
• Master cylinder cup (primary) 1
• Master cylinder cup (secondary) 2
To master cylinder piston 3.
NOTE:
Apply the brake fluid on the master cylinder
cup.
WARNING
After installing, cylinder cup should be
installed as shown direction. Wrong instal-
lation cause improper brake performance.
È Front
É Rear
3. Install:
• Spring 1
To master cylinder piston 2.
NOTE:
Install the spring at the smaller dia. side.
È Front
É Rear
5 - 19
CHAS
18 Nm (1.8 m · kg, 13 ft · lb)
3 Nm (0.3 m · kg, 2.2 ft · lb)
Publicité
