Publicité
TRANSMISSION, SHIFT CAM AND SHIFT FORK
c
2. Install:
NOTE:
• Apply the molybdenum disulfide oil on the
• Apply the lithium soap base grease on the O-
3. Install:
NOTE:
• Be sure the circlip sharp-edged corner a is
• Install the circlip with its ends c settled
c
4. Install:
NOTE:
• Apply the lithium soap base grease on the oil
• When installing the collar into the crankcase,
4 - 98
• Collar 1
• 2nd wheel gear (23T) 2
• 4th wheel gear (24T) 3
• 3rd wheel gear (23T) 4
• 5th wheel gear (20T) 5
• Collar 6
• 1st wheel gear (27T) 7
• O-ring 8
To drive axle 9.
inner and end surface of the idler gear and
on the inner surface of the sliding gear, then
install.
ring.
• Plain washer 1
• Circlip 2
New
positioned opposite side to the plain washer
and gear b.
evenly on the spline crests.
• Collar 1
seal lip.
pay careful attention to the crankcase oil seal
lip.
ENG
Publicité
