VHF R5 Mode D'emploi D'origine page 9

R5 – Operating regulations
Transportation and storage
WARNING
Injuries caused by unsafe transportation
If you transport the machine unsafely, the machine
may slip and cause injuries.
Always transport
vidually and do not stack them.
Ensure that only trained personnel transport the
machine to and from the installation site.
Ensure that the housing of the machine is com-
pletely closed.
Always transport the machine in an upright pos-
ition.
Transport and position the machine with
2 people.
Before carrying an unpacked machine, install the
carrying aid that was provided with the machine
and ensure that all components are properly fixed.
Do not use a different carrying aid
Grab unpacked machines only at the
handles of the carrying aid.
the machine when carrying it.
NOTICE
Short-circuit hazard when the machine is
too cold
If the machine is transported from a cold environment
into a warmer environment, a short circuit may occur
caused by condensate.
Before
switching on the machine after trans-
portation, ensure the following:
The ambient air has the allowed temperature.
n
The machine has the same temperature as the
n
ambient air. This will take
The machine is completely dry.
n
The supplement about the carrying aid and
transport lock is delivered with the machine.
It is also downloadable at
dentalportal.info/downloads
Ensure that the following conditions are met dur-
ing the whole transport and / or storage period:
unpacked
machines indi-
.
Do not tilt
at least
48 hours.
.
Original Operating Instructions: R5
Version: 5/10/2019
Ambient temperature (storage / transport):
n
between -20 °C (-4 °F) and 60 °C (140 °F)
Relative air moisture: max. 80 %, non-con-
n
densing
Preparing transportation or storage
Before transporting or storing your machine, the
following preparations are necessary:
1.
Remove all blanks from the working chamber.
2.
Remove all items from the blank magazine.
3.
If the machine was used for wet machining:
a.
Rinse the cooling liquid system.
b.
Drain and clean the cooling liquid tank.
4.
Clean the working chamber.
5.
Clean the blank magazine.
6.
Install the transport lock. For this, see the cor-
responding steps on the supplement.
7.
Ensure that the housing of the machine is com-
pletely closed.
8.
Switch off the machine at the main power switch.
9.
Disassemble the machine components by fol-
lowing the installation instructions in reverse
order.
10.
If you need to carry the machine, install the car-
rying aid. For this, follow the corresponding steps
on the supplement.
11.
In case of overseas transport, take proper meas-
ures against corrosion.
Repackaging
To repack the machine after preparing its trans-
portation or storage, the following steps are neces-
sary:
1.
If possible, use the original packaging. If the ori-
ginal packaging is not available, use a packaging
of similar size and quality.
Original packaging is available from
customer service.
2.
Pack the machine and its accessories securely.
3.
Protect the packaging against slipping. If
machines are properly packed and protected
against slipping, they may be stacked.
EN 9