VHF R5 Mode D'emploi D'origine page 47

R5 – Operation: Executing jobs
the tool type which you were prompted to insert.
Have a correct spare tool ready.
5.
Close the working chamber door. Restart the job.
DentalCNC allows you to resume the job from
the last machining step. For more information,
see the corresponding documentation.
If tools break regularly, you can find additional
information in the troubleshooting section: (
Troubleshooting – on page 67 )
How to proceed in case of a power failure
Damaging of the multi-purpose
compartment flap when you open it
manually
If compressed air is being conducted through the
machine while you open the multi-purpose compart-
ment flap, the flap mechanics may get damaged.

As long as the machine is not powered, you do not
have access to the working chamber.
F
IG
COMPARTMENT
Original Operating Instructions: R5
Version: 5/10/2019
NOTICE
Before you manually open the multi-purpose com-
partment flap, close the external compressed air
supply valve.
After a short power failure, restart the machine
and the CAM computer.
If you need to access the working chamber in case
of a longer power failure, perform an emergency
opening of the working chamber door.
If you need to access the multi-purpose com-
partment, do the following:
a.
Close the external compressed air supply
valve.
b.
Carefully pull the flap down with your
hands.
. 60 – M
ANUALLY PULLING DOWN THE FLAP OF THE MULTI
EN 47
-
PURPOSE