VHF R5 Mode D'emploi D'origine page 63

R5 – Maintenance and do-it-yourself
Updating the software and firm-
ware
Updating the firmware of the machine
The firmware is the internal control software of your
machine. New versions may introduce new functions
and improve existing ones. New firmware versions
come as part of new versions of DentalCNC.
NOTICE
Damaging of the control unit when a
firmware update is interrupted
If the firmware update is interrupted, the control unit
of the machine may become permanently damaged.
Only update the firmware if a permanent electrical
supply of the machine and the computer is guar-
anteed.
Only update the firmware if the computer's oper-
ating system is stable and is free of malware.
Only update the firmware if the connection
between the computer and the machine is stable.
Always use a wired connection during the update.
Do not disconnect the machine or the computer
from the electrical source nor switch off the
machine or computer during a firmware update.
Do not close DentalCNC during a firmware
update.
If the version of DentalCNC that is installed contains a
newer firmware, you will be prompted to update the
firmware when you start machining. The firmware
update should take 5 – 15 minutes to complete.
1.
To update the firmware, confirm the message.
You can cancel the message to postpone the
update, but we recommend updating the firm-
ware immediately.
2.
Wait until the update is complete.
3.
Switch off the machine at the main power switch.
4.
Restart the machine.
Updating the manufacturing software
DentalCAM and DentalCNC are updated regularly.
If an update is available:
1.
Switch to DentalCNC on the CAM computer.
DentalCNC informs you in the info area that an
update is available.
2.
3.
4.
5.
Original Operating Instructions: R5
Version: 5/10/2019
Update the software by clicking on the
depicted icon in the bottom right
corner of the DentalCNC window.
DentalCNC closes and the required installation
wizards launch.
Follow the installation wizards instructions.
Start DentalCNC.
For more information see the documentation for
the manufacturing software.
EN 63