VHF R5 Mode D'emploi D'origine page 28

EN 28
7. Disconnect
Switch to the
8. Allow auto-disconnect when a Request
Activate the
Use is received
check box.
9. Auto-disconnect timeout
From the
10
select .
10.
To save your settings, select
11. SMI PC Cam
Right-click on
12.
From the context menu, select
13.
Repeat steps 5 – 12 for the other
entry.
14.
In the SX Virtual Link window, locate the device
whose name starts with
for this device
Green check marks indicate that the connections
have been established.
F . 27 – T
IG HESE GREEN ICONS INDICATE SUCCESSFUL
CONNECTIONS
15.
In the SX Virtual Link application win-
dow, select the depicted icon.
Options
The window opens.
16. Options
In the window, activate the following
options:
Launch SX Virtual Link at Windows startup
n
Don't show SX Virtual Link main window on
n
program launch
Hide the main window if the close button is
n
clicked
17. Automatically connect newly dis-
Deactivate the
covered USB devices
option.
If you do not deactivate this option, you
will need to determine the port in
DentalCNC every time you start the
machine.
18.
To save your settings, select
19.
Start DentalCNC.
tab.
drop-down list,
[OK]
.
.
Connect
.
SMI PC Cam
FTDI
. Repeat steps 5 – 12
[OK]
.
Original Operating Instructions: R5
Version: 5/10/2019
R5 – Installing the machine
20.
Open the DentalCNC
this, select the following icon in the main icon
bar:
21. General settings
Open the
lowing icon in the lower icon bar:
22.
Select the following icon next to the
input field:
If DentalCNC is able to determine the port num-
ber, the number displays in the
input field. The machine references.
23.
In the SX Virtual Link application window, locate
the Ethernet address of the machine. It displays
behind the device name.
F . 28 – T E
IG HE THERNET ADDRESS OF THE MACHINE
)
ORANGE
24.
Enter the Ethernet address into the
ernet address
input field in DentalCNC.
Example:
84:25:3F:23:4A:F4
Double-check your entry.
25. <E >
Press .
NTER
From now on, DentalCNC will connect and dis-
connect the machine.
26. Launch application at Windows start
Activate the
up
option.
From now on, DentalCNC will launch with Win-
dows ® , which is required to automate the con-
nection process.
27.
Close DentalCNC.
If you do not close DentalCNC now, your
changes may not be saved.
28.
In the SX Virtual Link application window, right-
SMI PC Cam
click on .
29.
From the context menu, select
30.
Right click on the entry starting with
31.
From the context menu, select
The 2 check marks no longer display in the SX Vir-
tual Link application window, which indicates
that the machine is disconnected.
Application settings
. For
. For this, select the fol-
Port number
Port number
(
MARKED
Machine Eth-
Disconnect
.
FTDI
.
Disconnect
.