VHF R5 Mode D'emploi D'origine page 27

R5 – Installing the machine
22.
Follow the installation program. In the final step,
Start
select .
The installation program installs SX Virtual Link
and the machine device driver. When the install-
ation is finished, you will receive a corresponding
message.
23.
If the installation program asks you to restart the
CAM computer, do so. Otherwise, select
[Finish]
.
The CAM computer reboots or the installation pro-
gram closes.
24.
Continue with configuring SX Virtual Link and
DentalCNC (see below).
Configuring SX Virtual Link &
DentalCNC
1.
Ensure the following:
An Ethernet cable must be installed.
n
From now on, you can use a hub, router or
switch to connect the computer and the
machine.
The machine's network settings must be
n
configured.
SX Virtual Link is installed.
n
2.
If SX Virtual Link is not installed, open the install-
ation program in the DentalCAM & DentalCNC
USB\Silex\Util-
installation folder:
ity\Virtuallink\Cosetup.exe
3.
Open the SX Virtual Link application window:
The software should already be running –
n
select the arrow on the right side of your
task bar to open the system tray. In the sys-
tem tray, select the SX Virtual Link icon.
F . 23 – S
IG ELECTING THE ARROW AND THE
L
INK ICON
If the SX Virtual Link icon is not in the system
n
tray, start the application via the start menu.
You should find it in the
group.
.
SX V
IRTUAL
Silex Device Server
Original Operating Instructions: R5
Version: 5/10/2019
F . 24 – S SX V
IG TARTING
The SX Virtual Link application window displays.
If SX Virtual Link is able to find the machine in the
network, it is listed in the application window.
Otherwise, a corresponding image and message
display.
It may take a while before the device
becomes available. During this time,
Communication error
the device name.
F . 25 – M
IG ACHINE WAS FOUND IN YOUR NETWORK
1.
The internal devices of the machine
2.
The superior list entry for the machine
F . 26 – M
IG ACHINE COULD NOT BE FOUND IN YOUR NETWORK
4.
If the machine could not be found, check if the
CAM computer is properly connected to your
machine and that the machine is switched on and
started. You may want to try restarting the
machine.
5.
In the SX Virtual Link window, right-click on
PC Cam
.
6.
From the context menu, select
EN 27
L
IRTUAL INK VIA THE START MENU
is displaying after
SMI
Properties...
.