Hillrom Allen A-71100-CA Mode D'emploi page 77

Les langues disponibles

INSTRUCTIONS FOR USE

The Allen Advance Table will not go into Pendant Control Mode from the Manual

Make sure of these:

• The brakes are locked.

• The columns are at the same height.

• The Allen Advance Table and the installed support top are level "Level the Allen

Advance Table and the Support Top" on page 54.

• The Allen Advance Table is free of objects that could interfere with the adjustment.

• The flip handle is in the up and locked position.

If all of the conditions above are met, and the Allen Advance Table still will not go into the

manual flip mode, reset the power: press the On/Off switch to off and then to on.

The Pendant Control and Manual Flip Indicators are Flashing

Make sure that the flip handle is fully in the up and locked position or down and released

position. If the indicators continue to flash, reset the power: press the On/Off switch to off

and then to on.

The Brakes Locked and Unlocked Indicators are Flashing

Press and hold either the Brakes Lock or Unlock pendant control until the applicable

Brakes locked/unlocked indicator on the display stays on; the indicators are no longer

The Allen Advance Table "Beeps" when a Pendant Control is Pressed

A "beep" from the Allen Advance Table lets you know that the battery charge level is low

or depleted. Plug the Allen Advance Table into an applicable power outlet to charge the

batteries. To keep the batteries charged, plug the Allen Advance Table into an outlet

nightly and when you store the Allen Advance Table.

Service Calls

When you call Allen Medical about your unit, be prepared to give the serial number from

the product identification label. You will find the label on the inside of the head-end base

near the on/off switch.

Document Number: 80028198

Issue Date: 03 FEB 2023

Ref Blank Template: 80025117 Ver. F