Hillrom Allen A-71100-CA Mode D'emploi page 14

Les langues disponibles

INSTRUCTIONS FOR USE

EMC considerations:

If the Allen Advance Table is to be used near high-frequency surgical equipment,

cardiac defibrillators, and cardiac defibrillator-monitors, refer to the product

manufacturer's instructions to make sure the equipment will operate as intended.

This device meets all requirements for electromagnetic compatibility per

IEC 60601-1-2. Other products that are used near the Allen Advance Table should

comply with this standard also. Otherwise, electromagnetic interference

between the products could cause the products to operate incorrectly. If

problems do occur, contact the product manufacturer(s).

The A-71100-XX/A-71101-XX and A-71705-XX should not be used adjacent to

other electrical equipment. If adjacent use is necessary, observe the A-71100-XX/

A-71101-XX or A-71705-XX and the other electrical equipment to make sure they

operate as intended.

This device meets all requirements for electromagnetic compatibility per

IEC 60601-1-2. It is unlikely that the user will encounter problems with this device

because of inadequate electromagnetic immunity. However, electromagnetic

immunity is always relative, and standards are based on anticipated

environments of use. If the user observes unusual device behavior, particularly if

such behavior is intermittent and associated with nearby use of radio or TV

transmitters, cell phones, or electro-surgical equipment, this could be an

indication of electromagnetic interference. If such behavior occurs, the user

should try to move the interfering equipment further from this device.

Make sure the A-71100-XX/A-71101-XX and A-71705-XX operate correctly when

they are used near other electronic devices. Portable and mobile radio

frequency (RF) communications equipment can affect electrical equipment.

Medical equipment needs special precautions in regard to electromagnetic

compatibility (EMC) and needs to be installed and put into service according to

the EMC information supplied in the tables that follow.

Document Number: 80028198

Issue Date: 03 FEB 2023

Ref Blank Template: 80025117 Ver. F