Hillrom Allen A-71100-CA Mode D'emploi page 61

Les langues disponibles

INSTRUCTIONS FOR USE

• The Allen Advance Table is in the correct position for you to install a second

support top:

– The columns are at the same height.

– The Allen Advance Table and the installed support top are level. See "Level

the Allen Advance Table and the Support Top" on page 54.

– The Allen Advance Table is free of objects that could interfere with the

– All loose or unsupported objects have been secured.

• The Rail Top has the Prone Supports installed. If it does not, install them (see

Install the second support top as follows:

a. At one end of the Allen Advance Table, put the upper

H-bracket in position on the bowtie. Hold the H-

bracket so that the open end is down, the J ends are

toward you, and the H-bracket is angled toward you.

b. Install the J ends of the H-bracket on the bowtie so

that the H-bracket fits into the notches on the sides of

c. Insert the cross pin into the H-bracket, through the

bowtie, and through the other end of the H-bracket.

Do not use the H-bracket without the cross pin

installed correctly. To do so could cause patient fall,

injury, or equipment damage.

d. Make sure the drop lock on the end of the cross pin moves to the side to hold the

H-bracket in position.

e. Repeat steps Step a through Step d on the

opposite bowtie.

Determine which hole location on the H-

bracket to install the support top.

NOTE: The hole locations are numbered on the side of the H-brackets.

Document Number: 80028198

Issue Date: 03 FEB 2023

Ref Blank Template: 80025117 Ver. F