Hillrom Allen A-71100-CA Mode D'emploi page 42

INSTRUCTIONS FOR USE
Install the Lateral Bracket
This assembly is installed instead of the H-brackets or Advance Pinless H-Brackets to permit
the use of a lateral top and rail top with the prone support set during the same surgical
procedure.
1. If necessary, remove the support top and H-brackets (see page 38).
2. Make sure the brakes on the Allen Advance Table are
locked (the locked indicator on the Allen Advance Table
display is green).
3. Install the main support bracket so that the open end is
up.
a. Make sure that the hook feature of the main support
bracket is over the pin on the bowtie, then turn the
main support bracket until the crosspin hole in the
main support bracket aligns with the cross-pin hole in
the bowtie.
b. Insert the cross pin into the main support bracket,
through the bowtie, and through the other end of the
main support bracket.
WARNING:
Do not use the Lateral-to-Prone assembly without the cross pin installed correctly.
To do so could cause patient fall, injury, or equipment damage.
c. Make sure the drop lock on the end of the cross pin
moves to the side to hold the H-bracket in position.
d. Repeat Step a through Step c at the other end of the
table.
Document Number: 80028198
Version: F
Page 42
English
Issue Date: 03 FEB 2023
Ref Blank Template: 80025117 Ver. F