Hillrom Allen A-71100-CA Mode D'emploi page 67

Les langues disponibles

INSTRUCTIONS FOR USE

d. Pull the traction rope from the bowtie down and underneath the bar.

NOTE: The bar has an indentation to help keep the rope in position during cervical

The maximum weight load for the traction assembly is 50 lb (22.6 kg). To exceed

this weight could cause patient fall, injury, or equipment damage.

Make sure the traction weight is in a safe position, free from possible unintended

movement. Failure to do so could cause patient fall, injury, or equipment

Do not press the Cervical Traction Release button while traction weight is being

applied. To do so could cause the assembly to retract and the traction weight to

move. Patient fall, injury, or equipment damage could occur.

Use traction weight per facility protocols. Make sure that—

• The traction weight is in a safe position such that it is free from possible

unintended movement.

• The traction rope stays in the indented section of the cervical traction bar.

• You do not press the Cervical Traction Release button while traction weight is

being applied.

NOTE: The cervical traction bar is an optional accessory that is supplied to help with the

angle of pull for the cervical traction. If used, install the bar at the applicable location on

the H-bracket.

After use of the traction weight, remove the weight and the rope from the assembly.

Press the Cervical Traction Release button, and then push the assembly into the

column so that it is in the locked-in position.

Document Number: 80028198

Issue Date: 03 FEB 2023

Ref Blank Template: 80025117 Ver. F