Hillrom Allen A-71100-CA Mode D'emploi page 51

Les langues disponibles

INSTRUCTIONS FOR USE

Change the Height of the Advance Pinless H-Bracket

When you lift up on the Advance Pinless H-Bracket handles, the caregivers or

assistants must support the weight of the patient and the patient support top. Use

a minimum of three people at each Advance Pinless H-Bracket to support the

weight of the patient and the patient support, and operate the Advance Pinless

H-Bracket. Injury and equipment damage can occur.

Observe lines closely during articulations. Always use good line management

techniques. Failure to do so could cause patient fall, injury, or equipment

Make sure that you keep hands, fingers, tubes, and lines clear of the center of the

bracket when you adjust the height of the patient support surface. Failure to do

so could cause patient fall, injury, or equipment damage.

Use a minimum of three people at each Advance Pinless H-Bracket to raise the

Advance Pinless H-Bracket handles to adjust the height of the patient support.

a. One person should stand on the patient's left side to support the weight of the

patient and patient support top. One person should stand on the patient's right

side to support the weight of the patient and patient support top. The third person

should stand at the head or foot end as applicable and operate the lift triggers.

Lift up gently on the patient support so that the weight of the patient and the patient

support is held by the caregivers or assistants, not by the Advance Pinless H-Bracket.

Make sure that there are no objects between the patient support surface and the

floor before you lower the patient support surface or adjust the table. Failure to

do so could cause patient fall, injury, or equipment damage.

Press and hold the lift trigger to release the mechanism. Each lift trigger will operate

the other lift trigger.

Document Number: 80028198

Issue Date: 03 FEB 2023

Ref Blank Template: 80025117 Ver. F