Hillrom Allen A-71100-CA Mode D'emploi page 62

Les langues disponibles

INSTRUCTIONS FOR USE

Failure to use correct lifting methods could cause patient fall, injury, or equipment

g. With the help of another person, align the ends of the support top with the pre-

determined hole location.

Never remove a cross pin from a support top while a patient is on the support top.

Patient fall or injury could occur.

h. At each end of the support top, insert a cross

pin into the H-bracket, through the top

connector assembly, and through the other

end of the H-bracket.

Do not use the support top without the cross pins installed correctly through the

H-brackets. To do so could cause patient fall, injury, or equipment damage.

Make sure that—

• All cross pins are correctly installed into the H-brackets and support tops.

• The drop lock on the end of the cross pins has moved to the side to hold the

support tops and H-brackets in position.

Loosely install a minimum of four safety straps evenly spaced and around both

support tops.

NOTE: We recommend that you use the four Allen® Safety Straps that were included with

the support top.

Make sure the support tops are in the correct position, and then tighten the safety

Make sure the superior support top is progressively compressed against the patient

and once again tighten the safety straps.

Document Number: 80028198

Issue Date: 03 FEB 2023

Ref Blank Template: 80025117 Ver. F