Hillrom Allen A-71100-CA Mode D'emploi page 39

INSTRUCTIONS FOR USE
When the H-brackets and cross pins are not in use, they can
be stored on the inside of the columns.
3.2.6 Install the Advance Pinless H-Bracket
This assembly is installed instead of the H-bracket. For more detailed instructions for use of
the Advance Pinless H-Bracket, refer to the Advance Pinless H-Bracket IFU (D-720775-A1).
1. If necessary, remove the support top and H-brackets (see page 38).
2. Make sure the brakes on the Allen Advance Table are
locked (the locked indicator on the Allen Advance Table
display is green).
3. Do the steps that follow to open the mounting latch on both sides of the Allen®
Advance Pinless H-Bracket:
a. Press the release button on the mounting latch.
b. Move the release button away from the center of the Advance Pinless H-Bracket
to put the mounting latch in the open position. Make sure that the mounting latch
remains in the open position.
4. Do the steps that follow to put the Advance Pinless H-Bracket onto the bowtie:
a. Hold the Advance Pinless H-Bracket so that the
mounting latches are down, the lift handles are on the
side closest to the column, and the mounting grooves
are able to be put on the bowtie pins.
b. Install the top of the Advance Pinless H-Bracket on the
bowtie so that the Advance Pinless H-Bracket fits into
the notches on the sides of the bowtie.
Document Number: 80028198
Version: F
Page 39
English
Issue Date: 03 FEB 2023
Ref Blank Template: 80025117 Ver. F