Hillrom Allen A-71100-CA Mode D'emploi page 55

Les langues disponibles

INSTRUCTIONS FOR USE

NOTE: Near the bottom, on the outside of the columns, there

are numbers to help identify the height level.

If the support top is tilted, press and hold the opposite tilt control until the top is no

longer tilted. The tilt indicator on the display should be in the center of the tilt indicator

area, and the tilt level indicator should be green.

Rotate the Support Top 90°

Before you adjust the Allen Advance Table or use the flip or tilt features, make

sure that the brakes are locked, the patient is secured against the prone support

set, the patient is fully prepared for the adjustment; the Allen Advance Table is

free of objects that could interfere with the adjustment, and all loose or

unsupported objects have been secured. Otherwise, patient fall, injury, or

equipment damage could occur.

Make sure that—

• The brakes are locked (the locked indicator on the

Allen Advance Table display is green).

• The patient is secured to the support top and is fully

prepared for the adjustment.

• The Allen Advance Table is in the correct position for you to install a second

support top:

– The columns are at the same height.

– The Allen Advance Table and the installed support top are level. See "Level

the Allen Advance Table and the Support Top" on page 54.

– The Allen Advance Table is free of objects that could interfere with the

– The lateral top is flat and the air bladder is deflated.

– All loose or unsupported objects have been secured.

• The rail top has the prone supports installed. If it does not, install them (see

Document Number: 80028198

Issue Date: 03 FEB 2023

Ref Blank Template: 80025117 Ver. F