Hillrom Allen A-71100-CA Mode D'emploi page 66

Les langues disponibles

INSTRUCTIONS FOR USE

Access the Cervical Traction Assembly

The cervical traction release control is a push button on the upper-left side of the head-

Push the cervical traction release button. The assembly

moves out from the column.

Pull the assembly out from the column, and make sure the

assembly is in the locked-out position. The cervical

traction release button will return to its original position.

The maximum diameter of the traction rope should be 0.25" (6.35 mm). The use of

a traction rope that is greater than 0.25" (6.35 mm) in diameter could cause

binding inside the cervical traction assembly. Patient injury could occur as a result

of inaccurate traction.

Put the traction rope through the hole in the center of the

bowtie. The rope will go through the traction assembly

and out the left side of the column, near the release.

Put the traction rope over and around the pulley.

If desired, install the optional cervical traction bar on the

support top-side of the head-end H-bracket as follows:

a. Determine the hole location for the cervical traction

NOTE: The hole locations are numbered on the side of the H-

b. Put the bar into the H-bracket openings. Make sure that the bar is level by

verifying that each end of the bar is installed into the H-bracket at the same

numbered hole location.

c. Make sure the drop lock on each end of the bar moves to the side to hold the

bar in position.

Document Number: 80028198

Issue Date: 03 FEB 2023

Ref Blank Template: 80025117 Ver. F