Parker AC30 Série Mode D'emploi page 466

D-180
Parameter Reference
Spd Loop Diagnostics
Parameters::Motor Control::Spd Loop Diagnostics
Refer to the diagram in Spd Loop
Only applies to SVC control mode, IM or PMAC.
Parameter Name No.
Total Spd Demand RPM 0533
This diagnostic shows the final values of the speed demand in rpm obtained after summing all sources. This is the value which is
presented to the speed loop
Total Spd Demand % 0534
This diagnostic shows the final values of the speed demand as a % of 100% Speed in RPM of the Scale Setpoint obtained after
summing all sources. This is the value which is presented to the speed loop.
Speed Loop Error 0535
This diagnostic shows the difference between the total speed demand and the speed feedback
Speed PI Output 0536
This diagnostic shows the difference between the total speed demand and the speed feedback
Speed Limiter Active 0536
This diagnostic is TRUE if the drive is in Torque Control mode ( i.e. Sel Torq Ctrl Only is TRUE ), the speed limiter validated ( i.e. Spd
Limiter Torq Ctrl is TRUE ) and the drive is in speed limit condition.
Settings
function.
Path
Parameters::Motor Control::Spd Loop
Diagnostics
Parameters::Motor Control::Spd Loop
Diagnostics
Parameters::Motor Control::Spd Loop
Diagnostics
Parameters::Motor Control::Spd Loop
Diagnostics
Parameters::Motor Control::Spd Loop
Diagnostics
Default Range
x.xx -100000.00 to 100000.00
x.xx -200.00 to 200.00
x.xx -600.00 to 600.00
x.xx -600.00 to 600.00
x.xx to 600.00
-600.00
Units Writable
NEVER
RPM
NEVER
%
% NEVER
NEVER
%
%
NEVER
AC30 series Variable Speed Drive