Parker AC30 Série Mode D'emploi page 212

Parameter Name
Modbus Conn Timeout
Modbus TCP parameter.
Sets the Modbus connection timeout. If this parameter is set to zero then the connection will not timeout.
Modbus Mapping
Modbus TCP parameter.
User-defined Modbus parameter mapping table. Each entry in the table represents the required parameter number.
Mapping Valid
Modbus TCP parameter.
Status of the user defined mapping area. This will be set to TRUE if all entries in the mapping table are valid.
Modbus TCP Password
Modbus TCP parameter.
Modbus password. When set to a value other than zero, write access to parameters via the fixed mapping registers will be
restricted. To unlock the password, write to the Modbus register 00518 the value set in this password. A subsequent write of value
0000 to Modbus register 00518 will lock the password.
AC30 series Variable Speed Inverter
No. Path
1458 Setup::Communications::Base Modbus
Parameters::Base Comms::Modbus
1567 Setup::Communications::Base Modbus
Parameters::Base Comms::Modbus
1632 Monitor::Communications::Base Modbus
Parameters::Base Comms::Modbus
1659 Setup::Communications::Base Modbus
Parameters::Base Comms::Modbus
Fieldbuses
Default Range
66 seconds 0 – 100,000 seconds
none 0
Last parameter number
TRUE FALSE
TRUE
0000 0000
FFFF
A-10
Writable
ALWAYS
ALWAYS
NEVER
ALWAYS