Parker AC30 Série Mode D'emploi page 300

D-14
Parameter Reference
App Info
Parameters::Application::App Info
Details of the Application loaded in the Drive. An Application is built as part of a project using a suitable programming tool. When downloaded into
the Drive an Application within the Project can be selected to run. Some Projects only contain a single Application, so in this case will always be
selected.
Parameter Name No.
Project File Name 1040
The name of the file on the programming PC used to store the application. (This does not include the project or projectarchive file
name extension.)
0410
Archive Flags
Indicates if the source code corresponding to the loaded configuration in saved in the drive as an archive. For the AC30V the this
archive must be saved on the SD Card. On the AC30P the archive can be saved internally or on the SD Card.
Bit 0 Indicates that the project archive file on the SD card matches the loaded application
Bit 8 Indicates that the project archive file stored internally matches the loaded application
Last Modification 1047
Timestamp of when the loaded Project was last modified. (Note - the RTC option is not required for this.)
IDE Version 1048
The version of programming tool (Interactive Development Environment) used to create the loaded Project.
Project Author 1054
The Author of the loaded Project as entered in the programming tool when it was created
1061
Project Version
The Project version of the loaded Project as entered by the programmer when creating the Project.
Path
Parameters::Application::App Info
Parameters::Application::App Info
Parameters::Application::App Info
Parameters::Application::App Info
Parameters::Application::App Info
Parameters::Application::App Info
Default Range
1970/01/01 to 2106/02/07
Units Writable
NEVER
NEVER
NEVER
NEVER
NEVER
NEVER
AC30 series Variable Speed Drive