Parker AC30 Série Mode D'emploi page 336

D-50
Parameter Reference
Device Commands
Parameters::Device Manager::Device Commands
Parameter Name No.
Update Firmware 1002
This parameter is only visible when an SD card with a firmware update file is inserted into the drive. Changing this parameter to TRUE
will start the firmware update procedure.
Following a firmware update it is advisable to power re-run the Setup Wizard, D-61
Save All Parameters 1001
When a parameter is modified via the GKP or via the built-in web page the parameter value is saved automatically. When a parameter
is modified via another source, (for example via the Modbus TCP/IP communications protocol), the value will not be saved
automatically. In this case a save may be instigated by changing this parameter from FALSE to TRUE.
Path
Parameters::Device Manager::Device
Commands
Parameters::Device Manager::Device
Commands
Default Range
FALSE
FALSE
Units Writable
STOPPED
ALWAYS
AC30 series Variable Speed Drive