Parker AC30 Série Mode D'emploi page 348

D-62
Parameter Reference
Encoder Slot 2
Parameters::System Board::Encoder Slot 2
This feature allows you to setup and monitor the operation of the encoder attached to slot 2 of the system board.
Parameter Name No.
Encoder Lines 1671
The number of lines per encoder revolution
1672
Encoder Invert
Reverses the encoder direction if TRUE.
Encoder Type 1673
Normally the encoder will be quadrature. Exceptionally, eg if a proximity sensor or other pulse train is used, it needs to be clock /
direction.
High Input Threshold 1674
Changes the threshold level for the encoder pulses between 1.8 V and 6.5 V typical. For encoders powered from 5 V the low theshold
should be used. For other supply voltages the high threshold will provide greater noise immunity.
Encoder Speed 1675
The speed measured by the encoder, in revolutions per minute.
Encoder Count Reset 1676
Resets the encoder count.
Encoder Count 1677
The encoder count is a 32 bit count which will increment and decrement with the encoder pulses, up to (or down to) 2^31.
Path
Setup::Inputs and Outputs::SB Encoder
Slot2
Parameters::System Board::Encoder
Slot 2
Same as PNO 1671
Same as PNO 1671
Same as PNO 1671
Monitor::System Board::Encoder Slot 2
Parameters::System Board::Encoder
Slot 2
Same as PNO 1671
Same as PNO 1675
Default Range
2048 1 to 100000
FALSE
0 0:QUADRATURE
1:CLOCK/DIRECTION
FALSE
FALSE
Min to Max
Units Writable
STOPPED
STOPPED
STOPPED
STOPPED
RPM NEVER
ALWAYS
NEVER
AC30 series Variable Speed Drive