Cleaning And Maintenance - ARIETE 132 Mode D'emploi

CLEANING AND MAINTENANCE

Warning
Do not immerse the appliance, the plug or the power cord in water or other liquids. Clean them
with a damp cloth.
Even when the appliance is not in use, unplug it from the electrical outlet before inserting or
removing individual parts or before cleaning it.
Let it cool down before proceeding with the cleaning.
Never use metal utensils to remove the bread from the pan (L), in order to avoid damaging the
non-stick coating.
1) Clean the pan (L) rubbing the inside and the outside with a damp cloth.
2) If the kneading blade (I) does not come off from the motor shaft exceptionally fill the pan with hot
water and leave it for about 30 minutes. The blade must then be cleaned gently with a damp cloth.
3) Wash the measuring cup (M), the measuring spoon (N) in hot soapy water.
4) Clean all other surfaces, internal and external, with a damp cloth. Use a small amount of liquid
detergent if necessary, but be sure to rinse it completely, otherwise detergent residues could
compromise the successful outcome of your next bread.
TROUBLESHOOTING
In the event of malfunctions, switch off the appliance immediately.
Problems
The device gives
off a burning smell.
The ingredients do
not mix properly.
The error code
"HHH" is displayed
when the power
button is pressed.
The porthole is
steamed up and
covered with
condensation.
Causes
Flour or other ingredients may have
deposited in the baking compart-
ment.
The pan or kneading blade have not
been assembled correctly.
An excessive amount of ingredients
has been inserted.
The temperature inside the appliance
is too high.
The porthole may steam up dur-
ing the kneading and leavening
programs.
Solutions
Turn off the appliance and let it cool
completely. Eliminate excess flour
or other ingredients from the baking
compartment with a clean cloth.
Make sure that the pan and kneading
blade are installed correctly.
Measure out the ingredients thor-
oughly.
Let the appliance cool down between
a program and the other.
Unplug the appliance, open the lid
and remove the pan. Allow to cool for
15-30 minutes before starting new
programs.
It is a normal phenomenon.
Clean the porthole after use.
- 33 -
E N