Stryker Isolibrium PE Manuel D'utilisation page 19

R R e e s s e e t t t t i i n n g g C C P P R R
To reset the P P r r o o C C u u i i t t y y bed CPR status and reinflate the support surface:
1. Pull straight down on the red CPR support surface strap to reset the surface. In a slow motion, release the strap to its
original position. The support surface will reinflate when the CPR strap is reset. The status on the P P r r o o C C u u i i t t y y CPR
activated display will disappear (Figure 12).
2. If the support surface CPR strap was not pulled for CPR, the surface needs to be reset. The P P r r o o C C u u i i t t y y CPR Activated -
Surface Deflating display (Figure 13).
2973-009-005 Rev AF.0
F F i i g g u u r r e e 1 1 1 1 – – C C P P R R s s t t r r a a p p p p u u l l l l e e d d
F F i i g g u u r r e e 1 1 2 2 – – D D i i s s p p l l a a y y w w h h e e n n C C P P R R s s t t r r a a p p p p u u l l l l e e d d
15 EN