Pre-Op Instructions - Boston Scientific Precision SC-1110 Mode D'emploi

Precision™ Spinal Cord Stimulator System Clinician Manual

Pre-Op Instructions

1. Ensure that the IPG is fully charged prior to the permanent implant procedure. The
approximate location of the IPG is marked on the IPG kit. Turn on the Charger and place it
over the IPG to begin charging.
2. Check that the sterile package is intact (See "Sterilization, Handling, and Storage" on
page 14).
3. Ensure that a Trial Stimulator is available for use. Install a new battery in the Trial
Stimulator.
4. Be sure the Trial Stimulator and Remote Control stimulation settings have been reset (See
"Device Linking" on page 60).
5. For trial procedures, ensure that a Patient Trial Kit is available, proceed to "Percutaneous
Lead Placement in the Epidural Space" on page 17.
6. For permanent IPG implantation, proceed to "Removal of Trial Leads, Extensions, and
Splitters" on page 43.
Clinician Manual
91173656-02 16 of 385