Boston Scientific Precision SC-1110 Mode D'emploi page 71

Système de stimulation médullaire
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Place the Remote Control and the IR dongle in the plastic IR Holder so that their
communication ports are facing each other.
3. Plug the dongle's USB connector into the appropriate connector on the CP.
4. Launch the Bionic Navigator software and wait for the "Communication Established" message.
Note: • The Remote Control will remain CP Ready for up to 15 minutes with no activity.
• All buttons are active during CP Ready and pressing any button returns the Remote
Control to the Level screen.
• Stimulation may be turned on or off in CP Ready state.
• Whenever the Remote Control is re-activated from idle mode the display will default to
the Level screen.
The Clinician Programmer can communicate with either an External Trial Stimulator or an IPG.
Arrange for the patient to be seated within two feet of the Remote Control to ensure an
adequate communication link from the programmer to the Stimulator.
For instructions on how to use the Clinician Programmer with the Bionic Navigator software
to program the IPG and transfer programs to the Remote Control, see the Bionic Navigator
Software Guide.
Rechargeable Stimulator System
Clinician Manual
91173656-02
63 of 385

Publicité

Table des Matières
loading

Table des Matières