Boston Scientific Precision SC-1110 Mode D'emploi page 64

Precision™ Spinal Cord Stimulator System Clinician Manual
For BEST communication, your Remote Control should face the Stimulator.
• If there are no signal bars, communication may still be achieved at a very weak level.
Move the Remote Control closer to the Stimulator and/or reorient its position to improve
communication.
• If there are 1 or 2 signal bars, there is adequate communication between the Remote
Control and the Stimulator.
• If there are 3 or 4 signal bars, the Remote Control is achieving optimal communication with
the Stimulator.
• If communication is unsuccessful, the Remote Control will display the "Searching" message.
The Remote Control will then start continuously looking for a signal. Either reorient the
Remote Control so that it faces the Stimulator (see picture above), move the Remote
Control closer to the Stimulator, or move away from potential sources of interference.
To cancel searching press and hold the Area Button
Note: Avoid common sources of communication interference such as televisions and
computer monitors.
Note: Communication between the Remote Control and the Stimulator is not possible while
charging. Temporarily discontinue charging in order to use the Remote Control.
Clinician Manual
91173656-02 56 of 385
.
"