Connecting To The Trial Stimulator - Boston Scientific Precision SC-1110 Mode D'emploi

Connecting to the Trial Stimulator

Caution
• Keep the Trial Stimulator dry. It should not be exposed to moisture.
• Do not connect the Trial Stimulator to any other device except to the OR Cables provided
with it.
• Keep the Trial Stimulator away from pets, pests, and children to avoid damage to the
device.
1. If two leads are used, connect the cable labeled "1-L" to the upper or left lead, and the cable
labeled "2-R" to the lower or right lead. Labels are provided. If two 2x4 splitters are used,
connect the cable labeled "1-L" to the proximal connector of one of the splitters and connect
the cable "2-R" to the proximal connector of the other splitter. If using a Splitter 2x8 connect
the cable labeled "1-L" to the laser-marked tail and the cable labeled "2-R" to the unmarked
tail. If an Infinion™ CX lead is used, connect the cable labeled "1-L" to the tail with one
marker band and the cable labeled "2-R" to the tail with two marker bands.
2. Connect the OR cables to the Trial Stimulator.
If only one lead is used, connect the OR cable to "1-L" on the Trial Stimulator.
3. Fit the Trial Belt to the patient, cut off the excess length, and place the Trial Stimulator in the
belt pocket.
Connecting to the Trial Stimulator
Clinician Manual
91173656-02 41 of 385