Charging Steps - Boston Scientific Precision SC-1110 Mode D'emploi

Système de stimulation médullaire
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Precision™ Spinal Cord Stimulator System Clinician Manual
Failure to recharge may lead to loss of stimulation in less than 24 hours and the following
message will appear on the Remote Control: "Recharge Stimulator Now." After stimulation
stops, communication with the Stimulator will also cease and multiple recharge sessions
may be required. Until a sufficient level of charge has been attained, the Stimulator may not
communicate with the Remote Control.

Charging Steps

Caution
• Keep the charger and charging components dry. They should not be exposed to moisture.
• Do not connect the charger to any other device except to the Base Station provided with it.
• Keep the charger and charging components away from pets, pests and children to avoid
damage to the devices.
WARNINGS:
• Do not charge while sleeping. This may result in a burn.
• While charging, the Charger may become warm. It should be handled with care.
• Failure to use the Charger with either the Charging Belt or an adhesive patch, as shown,
may result in a burn. If pain or discomfort is felt, cease charging and contact Boston
Scientific.
The Charger Base Station should be plugged in and the Charger placed in the Base Station
when not in use. When the indicator light is green, the Charger is fully charged. When the
indicator is amber, the Charger is partially charged, but is still able to deliver a charge to the
Stimulator.
1. When the indicator light is green, remove the Charger from the Base Station. The indicator
light will then turn off.
2. Press the power button. The indicator light will come on again, and the Charger will begin
beeping as it searches for the Stimulator.
Clinician Manual
91173656-02
52 of 385

Publicité

Table des Matières
loading

Table des Matières