Wilo Stratos MAXO Notice De Montage Et De Mise En Service page 94

en-US
When the Wilo Net connection is established (see "Application and function of the Wilo Net interface
[" 121]" section), a list of available and appropriate twin-head pump partners will appear under "Connecting
twin-head pump".
Appropriate twin-head pump partners are pumps of the same type.
When the twin-head pump partner is selected, the display of this twin-head pump partner is switched on
(Focus mode). In addition, the blue LED will flash to identify the pump.
NOTICE
Activating the twin-head pump connection fundamentally changes various parameters of
the pump. The pump is then started automatically.
NOTICE
If there is an error in the twin-head pump connection, the partner address must be reconfig-
ured! Always check the partner addresses beforehand!
Menu "Disconnect twin-head pump"
When a twin-head pump function is established, it can also be separated. Select "Disconnect twin-head
pump" in the menu.
NOTICE
Disconnecting the twin-head pump function fundamentally changes various parameters of
the pump. The pump is then started automatically.
Menu "Types of DP housing"
The selection of the hydraulic position at which the motor head is installed takes place independent of a
twin-head pump connection.
The following selection is available in the "Types of DP housing" menu:
• Single pump hydraulic
• Twin-head pump hydraulics I (left in the direction of flow)
• Twin-head pump hydraulics II (right in the direction of flow)
With an existing twin-head pump connection, the second motor head automatically accepts the comple-
mentary setting.
• When the variant "Twin-head pump hydraulic I" is selected, the other motor head automatically adjusts to
"Twin-head pump hydraulic II".
• When the variant "Single pump hydraulic" is selected, the other motor head automatically adjusts to "Sin-
gle pump hydraulic".
94 Installation and operating instructions • Wilo-Stratos MAXO/-D/-Z • Ed.02/2023-10