Wilo Stratos MAXO Notice De Montage Et De Mise En Service page 33

7.2 Connecting the temperature sensor cable
The Stratos MAXO single pump is supplied without the temperature sensor cable already fitted.
NOTICE
Before the pump is put into operation, fit the temperature sensor cable supplied!
1. Connect the connector housing of the sensor cable onto the mounted temperature sensor in the suc-
tion channel of the pump housing.
2. Insert the plug at the other end of the sensor cable into the left connection point on the lower side of
the electronic module.
Fig. 10: Temperature sensor cable connection
7.3 Connection options
CAUTION
Risk of property damage!
Never connect the power supply to two phases with 400 V! This may destroy the electronic
system.
• Exclusively connect the power supply to 230 V (phase to neutral conductor)!
Installation and operating instructions • Wilo-Stratos MAXO/-D/-Z • Ed.02/2023-10
2
1
en-US
33