Wilo Stratos MAXO Notice De Montage Et De Mise En Service page 50

en-US
NOTICE
If there are no warning or error messages, the display on the electronic module will switch
off 2 minutes after the last time it was operated.
• If the operating button is pressed or turned again within 7 minutes, the previously exited
menu will appear. You can continue to configure settings.
• If the operating button is not pressed or turned for more than 7 minutes, any unconfirmed
settings will be lost. Pressing the button again opens the Home screen on the display and the
pump can be operated from the main menu.
Initial settings menu
The initial settings menu appears in the display on initial commissioning of the pump.
WELCOME - WILO-STRATOS MAXO
Start with factory settings
Pump works for radiator
Start venting
Automatic procedure
Initial settings
for commissioning
Fig. 19: Initial settings menu
If necessary, press the Context button
The pump runs on factory settings while the initial settings menu is being displayed.
If you do not want to make adaptations to the pump in the initial commissioning menu, select "Start with
factory settings" to quit the menu. The Home screen opens on the display and the pump can be operated
from the main menu.
After reinstallations we recommend venting the rotor chamber. For this purpose, activate "Start venting". A
venting routine starts in the background. Other settings can be configured while venting is active.
Open the "First settings" menu to configure the most important initial commissioning settings (e.g. lan-
guage, units, control mode, and setpoint) to adapt the pump to the required application. The chosen initial
settings are confirmed by activating "Finish initial settings".
Quit the Initial commissioning menu to open the Home screen on the display and operate it from the main
menu.
50
and go to the Language menu to change the language.
Installation and operating instructions • Wilo-Stratos MAXO/-D/-Z • Ed.02/2023-10
The pump has been
successfully installed!
Pump currently running on
factory settings:
Application:
Radiator
Control mode:
Dynamic Adapt plus