Wilo Stratos MAXO Notice De Montage Et De Mise En Service page 110

en-US
Set input for external setpoint
Select setpoint source
Set setpoint source
Substitute setpoint in the event of a cable break
Table 44: Set input for external setpoint
The setpoint source can be changed in select "Setpoint source".
Setpoint source
Fig. 49: Setpoint source
The setpoint source should be configured when an analog input is used as source. To do this, select "Set set-
point source".
Set input for external setpoint
Select setpoint source
Set setpoint source
Substitute setpoint in the event of a cable break
Table 45: Set input for external setpoint
Possible selection of type of use to be adjusted:
110
Internal setpoint
Analog input 1
Analog input 2
CIF module
Installation and operating instructions • Wilo-Stratos MAXO/-D/-Z • Ed.02/2023-10
Setpoint comes from
analog input (AI2)