Wilo Stratos MAXO Notice De Montage Et De Mise En Service page 71

1. "Set control mode"
2. "Setting assistant"
3. "Basic control modes" in sequence.
Application
Fig. 32: Application selection "Basic control modes"
The following basic control modes are available:
Basic control modes
‣ Differential pressure ∆p-v
‣ Differential pressure ∆p-c
‣ Index circuit ∆p-c
‣ Dynamic Adapt plus
‣ Volume flow Q-const.
‣ Multi-Flow Adaptation
‣ Temperature T-const.
‣ Temperature ∆T-const.
‣ Speed n-const.
‣ PID control
Table 17: Basic control modes
A control mode with temperature controller, index circuit Δp-c control and the PID control also requires the
selection of actual value- or sensor source (analog input AI1/AI2, internal sensor).
When you confirm a selected basic control mode, the "Settings assistant" sub-menu appears, displaying the
selected control mode in the information bar.
You see more menus under the display. These are intended for parameter configuration.
Installation and operating instructions • Wilo-Stratos MAXO/-D/-Z • Ed.02/2023-10
Heating
Cooling
Heating & cooling
Drinking water
Basic control modes
Select control modes
directly, no
allocation to an
application.
Settings help
en-US
71