Wilo Stratos MAXO Notice De Montage Et De Mise En Service page 106

en-US
Select type of use
Analog input (AI2)
Fig. 45: Settings dialog setpoint sensor
Type of use
Not configured
Setpoint sensor
Differential pressure sensor
Temperature sensor
External sensor
Table 42: Types of use
The following signal types are available depending on the type of use:
Type of use
Setpoint sensor
Differential pressure sensor
Temperature sensor
106
Not configured
Setpoint sensor
Differential pressure sensor
Temperature sensor
External sensor
Function
This analog input is not used. No settings required
Use analog input as setpoint sensor.
For example, delivery head.
Use analog input as actual value input for differential pressure
sensor.
For example, index circuit evaluator.
Use analog input as actual value input for temperature sensor.
For example for control mode T-const.
Use analog input as actual value input for PID control.
Signal type
• 0 ... 10 V, 2 ... 10 V
• 0 ... 20 mA, 4 ... 20 mA
• 0 ... 10 V, 2 ... 10 V
• 0 ... 20 mA, 4 ... 20 mA
• PT1000
• 0 ... 10 V, 2 ... 10 V
• 0 ... 20 mA, 4 ... 20 mA
Installation and operating instructions • Wilo-Stratos MAXO/-D/-Z • Ed.02/2023-10
Set analog input
as setpoint controller,
e.g. for delivery head