OnRobot Gecko Gripper Manuel De L'utilisateur page 223

Certifications
VGC10
CE/EU Declaration of Incorporation (Original)
According to European Machinery Directive 2006/42/EC annex II 1.B.
The manufacturer:
OnRobot A/S
Teglværskvej 47H
DK-5220, Odense SØ
DENMARK
declares that the product:
Type:
Model:
Generation:
Serial:
may not be put into service before the machinery in which it will be incorporated is declared in conformity
with the provisions of Directive 2006/42/EC, including amendments, and with the regulations transposing
it into national law.
The product is prepared for compliance with all essential requirements of Directive 2006/42/EC under the
correct incorporation conditions, see instructions and guidance in this manual. Compliance with all
essential requirements of Directive 2006/42/EC relies on the specific robot installation and the final risk
assessment.
Technical documentation is compiled according to Directive 2006/42/EC annex VII part B and available in
electronic form to national authorities upon legitimate request. Undersigned is based on the
manufacturer address and authorized to compile this documentation.
Additionally, the product declares in conformity with the following directives, according to which the
product is CE marked:
2014/30/EU — Electromagnetic Compatibility Directive (EMC)
2011/65/EU — Restriction of the use of certain hazardous substances (RoHS)
Relevant essential health and safety requirements of the following EU directives are also applied:
2014/35/EU — Low Voltage Directive (LVD)
2012/19/EU — Waste of Electrical and Electronic Equipment (WEEE)
A list of applied harmonized standards, including associated specifications, is provided in this manual.
Budapest, December 16th, 2019
Industrial Robot Gripper
VGC10
V1
1000000000-1009999999
Group Management
Vilmos Beskid
CTO
223