Removal And Replacement; Removal; Waste Disposal - Aventics RMC Mode D'emploi

64 AVENTICS | RCM | R402002349-BDL-001-AC

Removal and replacement

Risk of heavy objects!
Some configurations of the RMC-Zylinder are very heavy. Removing them or lifting them
incorrectly may cause injury.
Before detaching the cylinder from its fixings, make sure that it cannot fall.
When lifting the cylinder, take steps to avoid damaging it. Heavy cylinders must be
carried by two people or by one person with lifting aids.
8 Removal and replacement
8.1

Removal

The only time removal will be necessary is when replacing or
scrapping the device.
1. Switch off all compressed air from the relevant part of the
system.
2. Remove any devices that do not belong to the cylinder or its
shuttles, etc.
CAUTION
3. Remove all attachments and move the cylinder away from the
part of the system.
4. Pack the cylinder for transport or recycling.
5. Install the replacement unit as described in "Installation" on
page 49.
8.2

Waste disposal

Scrap the device in accordance with local regulations. Among
other things, the RMC-Zylinder contains lubricating grease that
may pollute the environment.