Aventics RMC Mode D'emploi page 61

Alternatively, attach the load to the slots on the upper face of the
shuttle:
Use 2
M6 for piston size 32 mm. Position the nuts symmetrically in
the shuttle slots.
Note: The maximum possible load is decreased when the load is
attached with nuts in the slots of the shuttle.
6.4.3
Normally the load is attached to the carriage with screws.
Replace transport screws with fixing screws (2 × 4) as follows:
Table 6:
Ø
Piston size
L2
25 mm
L1
32 mm
00123770
6.4.4
The load is attached either to the carriage with four fixing screws,
or with nuts in the slots on the upper face of the fixing plate.
When attaching with screws into the carriage, replace the four
transport screws with four fixing screws as follows:
Ø Table 7:
Piston size
L2
16, 25 mm
L1
32 mm
40-63 mm
00122493
When attaching with nuts in the slots, use 2
nuts. Position the nuts symmetrically in the shuttle slots. See
the product catalogue on the Internet for part number.
Note: The maximum possible load is decreased when the load is
attached with nuts in the slots of the shuttle.
AVENTICS | RCM | R402002349-BDL-001-AC
×
5 square M4 nuts for piston sizes 16 and 25 mm, and
RMC-MG Mini guide
Screw diameter L
M3
M3
RMC-HD heavy duty guide
Screw diameter L
M5
M6
M8
Installation
L L
1 2
3.5 mm 4.5 mm 8.0 mm
3.5 mm 6.1 mm 9.6 mm
L L
1 2
7.5 mm 12.5 mm 20 mm
9 mm 12.5 mm 21.5 mm
12 mm 14 mm 26 mm
×
5 square M6
59
+ L
1 2
+ L
1 2