Attaching A Load - Aventics RMC Mode D'emploi

58 AVENTICS | RCM | R402002349-BDL-001-AC
Installation
Note:
6. Fit the shock absorber (6) by screwing it into the stop and
adjust it to the correct position.
7. Lock the shock absorber with the nut (7).
8. Tighten the stop screws (8) so that they are slightly pressed
into the material of the cylinder body. Tightening torque 6 Nm.
6.4

Attaching a load

There are many ways of attaching a load to the RMC-Zylinder
shuttle. This section therefore only gives general information and
states which screw sizes can be used to attach to the different
types of cylinder.
Make sure that the load is properly attached for the specific
application, and that the attachment can handle the load for
which the cylinder is dimensioned.
6.4.1 RMC-BV Internal guiding
Generally used with one of the mountings available as accessories.
When attaching to the shuttle, use the screws listed in the table
below:
Table 4:
Piston size
16, 25 mm
32-80 mm
6.4.2 RMC-SB Slide bearing guide
The load is normally attached with screws in the holes in the
shuttle.
Use the screws listed in the table below:
Table 5:
Piston size
16, 25 mm
32 mm
Screw diameter
M4
M6
Screw diameter
M4
M6
Thread depth
6 mm
10 mm
Thread depth
6 mm
10 mm